BC Fishing Reports banner
1 - 1 of 1 Posts

·
Registered
Joined
·
468 Posts
I haven't had much luck with acceptable customer service and boat tops up here in the okanagan, I have used Valley custom covers as TNT mentioned and they do good work. However they will probably want your boat to fit the new tubes and Chwk. is a little out of the way. What about buying some tubing and buying or renting a tubing bender to take a shot at it yourself? The brackets and hinges are just riveted on so the biggest problem is just the bending. Try filling the tubing with sand when bending to reduce crushing. Or try Jerry's carline muffler in Kelowna, they bend up custom racks and roll cages etc. in fact they claim they can bend up anything.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top