BC Fishing Reports banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,812 Posts
Discussion Starter · #1 ·
Built this turbo dubbing brush block from some scrap lumber, a bearing from a router bit, the collet assembly from an Exacto knife, a knob I picked up at Princess Auto and a couple of hooks.
Fly Tyer magazine summer 2007 edition has the plans for building one, and if I can dig it up I will try and post it.



 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top